TACKLIFE TCS115E - Symbols

the switch is in the OFF position and the power source is the same as indicated on
the nameplate. Running at lower voltage will damage the motor.
WARNING: Repair or replace damaged or worn extension cords immedi- ately.
Select the appropriate extension cord gauge and length using the chart below.
When operating a power tool outdoors, use an outdoor extension cord marked "W-
A" or "W". These cords are rated for outdoor use and reduce the risk of electric
shock.
WARNING: Keep the extension cord clear of the working area. Position the cord so it
will not get caught on the workpiece, tools or any other obstructions while you are
working with the power tool.
MINIMUM GAUGE (AWG) EXTENSION CORDS (120V use only)
Amperage rating
Total length
More than
Not more than
25’(7.5M)
50’(15M)
100’(30M)
150’(45M)
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
12
16
14
12
Not Applicable
SYMBOLS
WARNING: Some of the following symbols may appear on the circular saw.
Study these symbols and learn their meaning. Proper interpretation of these
symbols will allow for more efficient and safer operation of this tool.
V
Volts
A
Amperes
Hz
Herts