TACKLIFE TCS115E - Laser On;Off Switch; Materials You Can Cut; General Cutting Note

LASER ON/OFF SWITCH
This saw is equipped with a laser guidance system for more precise cutting.
DANGER: Never allow the laser beam to shine into a person’s eyes. Serious eye
damage could result.
To turn the laser ON, press the left side of the laser switch (1) (Fig. 8). To turn the
laser OFF, press the right side of the laser switch.
Fig.8
MATERIALS YOU CAN CUT
The circular saw is a versatile saw that allows you to cut many different types of
materials. Some of the materials include:
• Wood products such as lumber, hardwood, plywood, composition
board and paneling
• Masonite and plastic
NOTE: There are several different types of blades available. Generally, blades with
carbide- tipped teeth cut better and stay sharp longer.
Tooth count and configuration are also important. High tooth counts cut slower
and are best suited for making smooth cuts on thinner materials such as paneling.
Use the correct blade for your application.
GENERAL CUTTING NOTE: Always make a test cut on a scrap workpiece to verify
that all settings are correct.
1. Make any adjustments to the saw before plugging it into the power source.
Adjustments include cutting depth, bevel cutting angle and edge guide (if installed).
2. Clearly mark the workpiece to locate the position of the cut.
3. Hold a smaller workpiece with a vise. Clamp a larger workpiece to a work bench
or table.