Need help?Do you have a question about the Taie FA230 and is the answer not in the manual?
Safety warnings for electric shock, power, and general usage.
Precautions for installation, environment, and wiring to prevent damage.
Wiring diagram and terminal connections for FY400 controller.
Wiring diagram and terminal connections for FY600 controller.
Wiring diagram and terminal connections for FY700 controller.
Wiring diagram and terminal connections for FY800 controller.
Wiring diagram and terminal connections for FY900 controller.
Wiring diagram and terminal connections for FA230 controller.
Wiring diagram and terminal connections for FA231 controller.
Steps for automatic tuning (autotuning) to set PID parameters.
Procedure for manually setting PID parameters (P1, I1, D1).
How to configure the alarm modes for the controller.
How to set the specific alarm values (e.g., AL1, AL2) for the controller.
Detailed list and explanation of parameters available in Level 1 (User Level).
Detailed list and explanation of parameters available in Level 2 (PID Level).
Detailed list and explanation of parameters available in Level 3.
Detailed list and explanation of parameters available in Level 4.
Function to monitor heater current and detect disconnections or reductions.
How the controller manages motor-driven valves for fluid flow regulation.
Flowchart for calibrating the 4-20mA linear output signal.
Detailed steps for calibrating CLO1 (low point) and CHO1 (high point).
Procedure for configuring the input for thermocouple sensors.
Procedure for configuring the input for RTD sensors.
Procedure for configuring the input for linear 4-20mA signals.
Detailed steps for calibrating linear input signals (ANL1, ANH1, DP).
General| Control Mode | PID, ON/OFF |
|---|---|
| Display | Dual 4-digit LED |
| Mounting | Panel Mount |
| Input Type | Thermocouple, RTD |
| Output 1 | Relay, SSR |
| Output 2 | Relay, SSR |
| Alarm Output | Relay |
| Power Supply | 100-240 VAC |
To Next Page