Tait
T2030II - Getting Started

11
English
Introduction The T2030/35 Series
II of trunked radios may be used
to make the following types of call:
• Speech calls to other radios, both in your own fleet
and in different fleets.
• Speech calls on a telephone network.
• Status message calls to a preprogrammed destination
(such as your despatcher).
Variation in
radio setup
Your T2030/35
II is microprocessor controlled so that it
can be configured to suit the needs of your fleet. For this
reason, some features described in this guide may
operate differently on your radio.
If a feature does not operate as described, consult your
Tait dealer for further assistance.
Switching the
radio on
To switch the radio on, turn the On/Off-Volume control
to about one third of its maximum setting. You may need
to re-adjust the volume when you receive your first call.
The SVC (service) indicator will normally glow within a
few seconds. If it does not, you may be outside your
network’s coverage area.
Using the
Microphone
and PTT key
During a call, use the PTT key to switch the radio
between receive and transmit modes.
Press the PTT key to talk, release it to listen.
The TX indicator glows during transmission.
Getting Started