13
English
Receiving Calls
When you
receive a
call
The tones used to alert you to an incoming call may
vary, depending on how your radio is programmed and
the type of network you are using.
Both types of alert tone are illustrated below, alongside
instructions for answering the different types of incoming
call.
Identifying
the caller
If the call is from a location that is programmed as a
preset for your radio, then the radio will display the
preset ID as follows:
T2030
II
The appropriate preset key indicator will light.
T2035
II
The caller’s preset number will show on the display.
Additional information may be displayed on the T2035
II:
Tone: To Answer:
Two tones
A single tone
This is a Direct Call. When the GO
indicator lights, lift the microphone
and respond to your caller.
A ringing tone
This is a Request Call. Either:
1 Lift the microphone off-hook.
• Wait while your radio sets up the call.
• Respond when the WAIT indicator
goes out and the GO indicator lights,
or
2 Press the Clear ( ) key to reject
the call.
If the call is:
The T2030/35
II
displays:
From within your fleet
From outside your fleet
From a telephone
Unidentifiable
the caller’s fleet ID
.1.
.2. or .3.
.4.
or
To Next Page
Loading...