Tait
T2030II - Returning Calls

14
English
Use the memory features described below to re-
establish earlier calls and return unanswered calls.
Callback When an incoming call finishes, your radio stores the
caller’s number. The CALLBACK indicator glows in the
T2030
II, and the caller’s preset number or ID flashes on
the display of the T2035
II.
To return the call, press the Callback () key
(T2030
II), or the Call ( ) key (T2035II). Wait for
the GO indicator to light, and proceed as usual.
You may also be able to initiate a callback by squeezing
the PTT key briefly (depending on how your radio is
programmed).
Redial The last number you called is also stored in your radio’s
memory. To call that number again, press the PTT key.
If your radio is in callback mode, press the Clear ()
key to discard the callback ID before redialling.
Call Queuing
(T2035
II only)
Your T2035
II may be programmed to queue up to 20
unanswered call IDs.
To access the queue, press the Queue ( ) key and
hold the Despatcher ( ) key for approximately one
second. The QUEUE indicator will light. Press the
Despatcher ( ) key again to leave the queue.
In queue mode, press the Queue key to scroll through
the list of IDs. When you reach the end of the list, the
radio will beep and reverse the scrolling direction.
To return a call to any of the listed IDs, press the PTT
key or the Call ( ) key when that ID is displayed. To
delete an ID from the list, press the Clear () key.
Returning Calls