150 Disassembly and Re-assembly of Radio TM8100 Mobile Radio Service Manual
May 2004 © Tait Electronics Limited
Re-attach Control Head Re-attach the control head to the radio body as follows. The procedure
applies both to the blank control head and to control heads with UI.
1. Orient the control head with respect to the radio body as noted in
Subsection 6.1 (on page 127).
2. Reconnect the control-head loom to the connector on the radio
body. Refer to Figure 6.2.
3. Align the control head with the inner face of the radio body.
Ensure that the control-head loom folds properly into the space
between the control head and the radio body.
4. Press the control head against the radio body until it clips into
position. Ensure that the seal is not damaged in the process.
5. Continue with the servicing procedure detailed in Subsection 5.2
(on page 109).
To Next Page
Loading...
Need help?
General
