Takagi GS-20W-AU5 - Remote Controller Installation

15
WARNING
• DO NOT locate the remote controllers where they may come into contact with water.
• 
• 
• 
• -
SULATION PLATE SHOULD BE PROVIDED BEHIND THE MOUNTING POSITION.
REMOTE CONTROLLER INSTALLATION
1. Crimp the fork terminals provided to the wires.
• Minimum 18AWG wire (No polarity)
• Maximum 100m long
2. 
controller.
3. Install the wiring downward through the cable trench and

4. 

Use the fork terminals
25 mm
45 mm
REMOTE CONTROL WIRING
Connector base
83.5 mm