3-10
OPERATION
OPERATING THE TRAVEL LEVERS
Warning
•Neverallowanyonetoenterthe
machine’s slewing radius and path.
•Signalyourintentiontomoveby
sounding the horn.
•Thereisablindspotintherearofthe
machine. Before traveling in reverse, as
necessary, swing the cab around in
reverse to check that the area is safe
and clear.
OPERATING THE MACHINE
•Beforeoperatingthetravellevers/
pedals, make sure that the dozer blade
is to the front of the operator’s seat.
Remember that when the dozer blade is
to the rear of the operator’s seat, the
travel levers/pedals must be operated in
the reverse direction from when it is to
the front.
•Clearallobstaclesfromthepathofthe
machine.
1.
Turn the throttle controller and increase
the engine speed.
2.
Fully lower the safety lock lever to
disengage the lock.
3. Fold the hoe attachment and lower it 30 to
40 cm (12 to 16 in.) above the ground.
4.Lift
thedozerblade.
5. Operate the left and right travel levers as
below.
Moving the machine forward and
backward
To Next Page
Loading...
Need help?
General
