Takeuchi TB285 User Manual

5-17
MAINTENANCE
INSPECTING AND REPLENISHING THE
ENGINE OIL
Warning
Stop the engine and allow the machine to
cool down before performing
maintenance.
Inspection
<TB285>
DAILY INSPECTION (EVERY 10 HOURS)
<TB290>
1.
Open the engine hood.
2. Take out the dipstick (1) and wipe the oil
off with a rag.
3. Fully reinsert the dipstick (1), and then pull
it back out.
4.
Check the oil on the dipstick (1).
The level should be between the upper
limit(H)andthelowerlimit(L).
 Ifitisbelowthelowerlimit(L),replenish.
Replenishing
1.
Remove the oil filler cap (2).
2.Addoiluptobetweentheupperlimit(H)
andthelowerlimit(L)ofthedipstick(1).
Problems could arise if the oil level is either
too low or too high.
3. Tighten the oil filler cap (2).
4. Start the engine, run it at low idle for about
5 minutes, then stop it.
5. After about 10 minutes, inspect the oil
level.

Takeuchi TB285 Specifications

General

Brand	Takeuchi
Model	TB285
Category	Excavators
Language	English