Takeuchi TB285 - Replacing the Feed Pump Filter <TB290

5-47
MAINTENANCE
REPLACING THE FEED PUMP FILTER
<TB290>
Warning
•Donotsmokeorpermitopenames
while handling fuel or working on the
fuel system.
•Stoptheengineinawell-ventilated
place and allow it to cool down before
performing maintenance.
•Cleanupspilledfuelimmediately.
1.
Open the side cover.
2. Place a pan under the feed pump (1) to
catch fuel.
3. Remove the cover (2).
4. Remove the element (3) and gaskets (4).
5. Install the new element and gaskets.
6. Install the cover (2).
7. Bleed air.
Refer to “Bleeding air from the fuel
system” on page 6-8.
EVERY 500 HOURS