6-5
TROUBLESHOOTING
Disconnecting the jumper cables
Once the dead machine is successfully
running,removethejumpercablesby
following the same steps as for connection in
the reverse order.
1.Disconnecttheclipofjumpercable(B)
from the engine block of the dead
machine.
2.Disconnecttheotherclipofjumpercable
(B) from the negative (–) battery terminal of
the booster vehicle.
3.Disconnecttheclipofjumpercable(R)
from the positive (+) battery terminal of the
booster vehicle.
4.Disconnecttheclipofjumpercable(R)
from the positive (+) battery terminal of the
dead machine.
Recharging
Ask your sales or service dealer for
recharging the dead battery.
IF THE BATTERY GOES DEAD
To Next Page
Loading...
Need help?
General
