1-32
SAFETY
Have a Takeuchi service agent repair
welding
If welding must be performed, make sure
that it is done by a qualified person in a
properly equipped workplace. To prevent any
part from breaking down or being damaged
due to overcurrent or sparks, observe the
following.
•Disconnectthewiringfromthebattery
before doing electric welding.
•Donotcontinuouslyapply200Vormore.
•Theearthgroundmustbeconnected
within one meter from the welding section.
Do not connect the earth ground near to
an electronically controlled device/
instrument or connectors.
•Makesurethattherearenosealsor
bearings between the welding section and
the earth ground.
•Donotconnecttheearthgroundaround
the pins for the working equipment or
hydraulic cylinders.
•Whenweldingistobedoneonthe
machine body, disconnect the connectors
for the electronically controlled devices
before working.
PRECAUTIONS ON MAINTENANCE
Vibrations operators are subject to
According to the results of the tests
conducted to determine the vibrations
transmitted to the operator by the machine,
theupperlimbsaresubjectedtovibrations
lower than 2.5 m/s
2
(8.2 ft/s
2
) while the
seatedpartofthebodyissubjectedto
vibrations lower than 0.5 m/s
2
(1.64 ft/s
2
).
Checks after maintenance
•Gradually
increasetheenginespeedfroma
low idle to maximum speed and check that
there is no oil or water leaking from the
serviced parts.
•Operateeachcontrolleverandcheckthat
the machine is operating properly.
Disposing of wastes
•Alwayscollectoilthatisdrainedfromthe
machine in containers. Improperly
disposed waste oil can cause
environmental harm.
•Followappropriatelawsandregulations
whendisposingofharmfulobjectssuchas
oil, fuel, coolant, solvent, filters and
batteries.
Handling of poisonous chemicals
Poisonous
chemicalswillcauseseriousinjury
if directly contacted.
Poisonous chemistry used in this machine
includes grease, battery solution, coolant,
paint and adhesive agent.
Handlethepoisonouschemicalsproperly
with care.