3-11
OPERATION
OPERATING THE MACHINE
• Before traveling on a road, tilt the
reflector. When operating at a job site,
raise the reflector to prevent it from
being damaged.
< For Germany >
Equipped with outrigger
• Before operating the travel pedal, make
sure that the steering device is to the
front of the operator’s seat. Remember
that when the steering device is to the
rear of the operator’s seat, the steering
wheel must be operated in the reverse
direction from when it is to the front.
• Do not raise the safety lock lever or turn
the starter switch to the OFF position
while traveling. Doing so is dangerous
because it activates the parking brake
and causes the machine to stop suddenly.
• When traveling during nighttime hours,
be sure to install the position lights.
Loosen the bolt (1) and install the light.
To prevent damage, remove the position
lights (including the brackets and
harness) before working at the site.
• Never allow anyone to enter the
machine’s slewing radius and path.
• Signal your intention to move by
sounding the horn.
• There is a blind spot in the rear of the
machine. Check that the area is safe
and clear for yourself. When necessary,
use the rear camera.
To Next Page
Loading...
Need help?
General
