5-27
MAINTENANCE
AFTER THE INITIAL 50 HOURS (ONLY FOR NEW MACHINES)
Engine oil filter
7. Place a pan for catching the waste oil
under the engine oil filter.
8. Remove the drain plug (4) and drain the oil
from the filter case (6).
9. Loosen the bolt (5) and remove the filter
case (6).
10. Clean the inside of the filter case (6) and
install a new element (7).
11. Clean the surface to install the filter stand
and coat the new O-rings with thin oil.
12. Install the case (6) and secure it with the
bolt (5).
· Tightening torque: 44.1 N·m (32.5 ft-lb.)
13. Install the drain plug (4).
· Tightening torque: 24.5 N·m (18.1 ft-lb.)
14. Add oil up to between the upper limit (H)
and the lower limit (L) of the dipstick (1).
Problems could arise if the oil level is
either too low or too high. It takes around
15 minutes for all of the added oil to go
down to the oil pan.
15. Tighten the oil filler cap (2).
16. Start the engine, run it at low idle for
about 5 minutes, and then stop it.
17. After about 10 to 20 minutes, inspect the
oil level.
To Next Page
Loading...
Need help?
General
