Tanaka TCH 22EAP2 - Operating Procedures; Fuel and Fueling; Starting the Engine; Cutting Operation

4
English
(Original instructions)
MEANINGS OF SYMBOLS
NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning before use.
It is important that you read, fully understand and
observe the following safety precautions and
warnings. Careless or improper use of the unit may
cause serious or fatal injury.
Emergency stop
Read, understand and follow all warnings and
instructions in this manual and on the unit.
Fuel and oil mixture
Always wear eye, head and ear protectors when using
this unit.
Hot surface
Choke - Run position (Open) Guaranteed sound power level
Choke - Choked position (Closed)
Before using your machine
• Read the manual carefully.
• Check that the cutting equipment is correctly
assembled and adjusted.
• Start the unit and check the carburetor adjustment.
See “MAINTENANCE”.
On/Start
Off /Stop
Contents
WHAT IS WHAT? .............................................................................. 5
WARNINGS AND SAFETY INSTRUCTIONS .................................. 6
SPECIFICATIONS ............................................................................ 7
OPERATING PROCEDURES ........................................................... 7
MAI NT ENA NCE ................................................................................ 8
TROUB LESHOOTIN G ...................................................................... 9
000BookTCH22EAP2(50ST)WENE.indb4000BookTCH22EAP2(50ST)WENE.indb4 2014/12/0516:15:162014/12/0516:15:16