If the pump is new or reassembled after maintenance it is important to retighten the pump
housing screws / nuts (pos. 37) after a few days of operation.
Make sure to use the right torque – see chapter 6.5 Tightening torques.
When installation is new, a test run of the pump should be conducted. Gauge the capacity at
specific air pressure/flow. This information is useful for checking performance in the future as
wear takes place. You will be able to set schedules for maintenance of the pump and to select
spare parts to be kept on stock.
Frequent observation of the pump operation is recommended to detect problems. A change
in sound of the running pump can be an indication of wearing parts (see chapter 3.4 "Location
of faults" below).
Leaking liquid from the pump and changes of performance may also be detected. Routine
inspections should be conducted frequently.
The intervals for a complete inspection depend upon the operation conditions of the pump.
The characteristics of the liquid, temperature, materials used in the pump and running time
decide how often a complete inspection is necessary.
Nevertheless, we recommend to inspect Tapflo pumps at least once a year by the end user.
Parts from KIT AIR and KIT LIQ should be changed during inspection.
See paragraph 5.3 for detailed kits content.
If a problem has occurred, or if the pump is in need of a complete inspection, refer to chapters
3.4 "Location of faults" and 3.5, 3.7 "Dismantling of the pump". You are of course warmly
welcome to consult us for further help.
Parts that are subject to wear should be kept in stock, see our recommendations in chapter 5.3
“Stocking recommendation”.
To Next Page
Loading...
