Tapworks AD11 User Manual

Programming
Please Remember – Only use tablet or pellet salt in your softener!
22
When the transformer is first plugged in, the display will flash 12.00am.
Note: Each time you press a button on the fascia panel display, a beeper
sounds. One beep signals that a change is accepted. If the beeper sounds
continually then a different button is
required to affect the operation.
SET THE PRESENT TIME
The display will continue to flash and the
time can be advanced or moved
backwards using the s or t buttons.
Holding down the buttons advances the
time at a faster rate.
If the time requires resetting during normal operation, press the SELECT button
once. The display will flash and indicate present time. You may use the
s or t buttons as described above to alter the time. Once the required time
is displayed the time may be set by pushing the SELECT button once more.
SET THE WATER HARDNESS CALCULATION
The display will flash ’25 hardness’ (this is a pre-set factory setting).
Hardness varies from one location to another. Use the kit provided to
determine your water hardness in ppm. If necessary change to the unit
setting indicated.
12 :00
AM
PRESENT TIME
Programming the AD11 & AD15 Faceplates
ppm Unit Setting
(170) 10
(190) 11
(200) 12
(220) 13
(240) 14
(255) 15
(270) 16
(290) 17
(300) 18
(325) 19
(340) 20
(360) 21
(380) 22
(400) 23
(420) 24
(440) 25
(460) 30
(480) 30
(500) 35
WATER HARDNESS

Tapworks AD11 Specifications

General

Brand	Tapworks
Model	AD11
Category	Water Dispenser
Language	English