Programming
To increase or decrease the displayed number to your required setting
use the s or t buttons.
Once the required setting is displayed it may be set by pushing the
SELECT button once more.
SET THE RECHARGE TIME
The display will flash 02.00 recharge time, which is the pre-set factory
setting. If you wish to change this time then proceed as follows:
(if not, press SELECT and proceed to the next section).
Note: 2.00am is chosen because any household water used during
recharge will be replaced with hard water. Consequently a time is
required when very little, if any, water will be used. To select a
different recharge time use the s or t buttons, to adjust one hour at
a time. Once the required setting is displayed it may be set by
pressing the SELECT button once more. Recharge will last for
approximately 1 hour.
1
5
HARDNESS
2:
00
AM
PRESENT TIME
Programming the AD11 & AD15 Faceplates
Please Remember – Only use tablet or pellet salt in your softener!
23
To Next Page
Loading...
