User information
Please Remember – Only use tablet or pellet salt in your softener!
24
TO RECHARGE TONIGHT
The unit can be programmed
to recharge at the next
pre-programmed time, regardless
of its remaining capacity. This is
particularly beneficial to ensure a
sufficient softened water supply for
an expected heavy water usage the next day.
Simply press the TOUCH/HOLD button once. Recharge tonight
will flash on the display.To cancel recharge tonight, press the
TOUCH/HOLD button once and immediately release. The display
will return to the time display.
TO RECHARGE NOW
Alternatively, a manual recharge
can be initiated at any time.
Simply press the TOUCH/HOLD
button and hold it down for
approximately 3 seconds, until a
beep sounds.Recharge will flash on
the display. The process will take a few minutes to begin and last
approximately 1 hour.
It cannot be cancelled once started.
Use as little water as possible during this time period as hard water will
bypass the water softener. Once the recharge is complete the recharge
display will disappear.
NOTE: The unit will automatically flash ‘recharge tonight’ once the
computer calculates that a recharge is required. This is for information
only – no action is required. At the next programmed recharge time the
cycle will automatically begin. Once a recharge is initiated a flashing
‘recharge’ replaces the flashing ‘recharge tonight‘.
Programming the AD11 & AD15 Faceplates
9:
10
AM
RECHARGE TONIGHT
1 1
:00
AM
RECHARGE
To Next Page
Loading...
Need help?
General
