Need help?Do you have a question about the Taramps DS 4000X4 and is the answer not in the manual?
Key safety instructions for installation and operation to prevent injury or product damage.
Configure input sensitivity and gain levels for optimal audio signal matching.
Select amplifier's audio band amplification: Full Range, High Pass, or Low Pass.
Use high-level signals for auto turn-on, bypassing remote wire.
Details the internal fan and necessary clearances for effective amplifier cooling.
Properly connect speakers, minding polarity and minimum impedance for safety.
Connect power to battery and head unit remote for amplifier operation.
Understand LED status for ON, PROT, and diagnostic flashes indicating protection events.
Specifies recommended wire gauges for power/speaker cables and appropriate fuse ratings.
General| Channels | 4 |
|---|---|
| Frequency Response | 10Hz - 20kHz |
| Signal to Noise Ratio | >90dB |
| Operating Voltage | 9V - 14.4V |
| Efficiency | > 85% |
| Minimum Supply Voltage | 9V |
| Maximum Supply Voltage | 14.4V |
| Power Output @ 12.6V @ 1 Ohm | 4000W |
To Next Page
