Taramps DS 800X4 User Manual

1 OHM
2 OHMS
4 x 200W RMS
A instalação deste produto deverá ser feita por um profissional qualificado.
The installation of this product must be made by a qualified professional.

Taramps DS 800X4 Specifications

General

Power Output	800W RMS
Number of Channels	4
Impedance	2 Ohms
Signal to Noise Ratio	>90dB
Crossover	Yes
Power @ 13.8V @ 2 Ohms	200W x 4
Power @ 13.8V @ 4 Ohms Bridged	400W x 2
Crossover High Pass Filter	90Hz
Crossover Low Pass Filter	90Hz
Minimum Impedance Output Stereo	2 Ohms
Minimum Impedance Output Bridged	4 Ohms

Summary

Introduction

Safety Requirements and Warnings

Essential guidelines, warnings, and safety symbols for amplifier use.

Declaration of Conformity

Functions and Inputs

Signal Input Terminals

Details on RCA and high-level inputs for connecting audio sources.

Crossover Control Options

Explanation of crossover modes (FULL, HPF, LPF) for frequency filtering.

LED Status Indicator

Indicates the operational status of the amplifier.

Output and Power Connections

Speaker Output Configuration

Instructions for connecting speakers, including impedance and bridging.

Power Supply and Remote Input

Guide for connecting the amplifier to the 12V power source and remote terminal.

Amplifier Protection System

Description of the amplifier's output overload and short-circuit protection.

Installation Procedures

Wire Gauge and Fuse Recommendations

Specifies appropriate wire gauges and fuse rating for safe installation.

Installation Safety Precautions

Important safety notes and warnings during the installation process.

Technical Specifications