Need help?Do you have a question about the Taramps MD 800.1 and is the answer not in the manual?
General| Number of Channels | 1 |
|---|---|
| Operating Class | Class D |
| Signal to Noise Ratio | >90dB |
| Crossover Low Pass (LPF) | 50Hz - 250Hz |
| Input Impedance | 10k Ohms |
| Output Impedance | 2 Ohms |
| Idle Consumption @ 12.6 VDC | 0.8A |
| Operating Voltage | 12V |
| Maximum Power @ 12.6 VDC - 2 OHMS | 800W |
| Bass Boost | 0dB - 12dB |
| Protection System | Short Circuit |
| Minimum Supply Voltage | 9V |
| Maximum Supply Voltage | 16V |
| Power Output (RMS) | 800W RMS @ 2 OHMS |
Essential advice for optimal amplifier installation and usage.
Adjust High Pass and Low Pass filters for operating frequency range.
Instructions for connecting positive and negative power supply cables.
Overview of short-circuit, low voltage, and high voltage protections.
Specifies recommended wire gauges and fuse ratings for safe installation.
Details minimum output impedance and power output at various loads.
To Next Page
