Need help?Do you have a question about the Taramps Bass 400 and is the answer not in the manual?
General| Power Output @ 1 Ohm | 400W RMS |
|---|---|
| Power Output @ 2 Ohms | 250W RMS |
| Number of Channels | 1 |
| Signal to Noise Ratio | >90dB |
| Crossover Low Pass (LPF) | 50Hz - 250Hz |
| Input Impedance | 10k Ohms |
| Impedance Output | 1 Ohm |
| Dimensions (mm) | 134 x 42 x 176mm |
| Weight (kg) | 0.68Kg |
Provides essential advice for optimal amplifier performance and safe operation during installation and use.
Connects amplified outputs (wires) from CD/DVD players; utilizes audio recognition for automatic turn-on.
Inputs for signals to be amplified via RCA outputs using shielded cables to prevent interference.
Adjusts amplifier input sensitivity for optimal output signal levels from various audio sources.
Variable adjustment from 55Hz to 250Hz, defining the amplifier's upper operating frequency limit.
Variable adjustment from 8Hz to 30Hz, defining the amplifier's lower operating frequency limit.
Boosts bass signals with a variable range from 0 to +12dB.
Sets the Bass Boost center frequency from 35Hz to 55Hz.
The 'ON' LED indicates that the amplifier is powered on.
Connects to the negative battery pole using a 4mm² (11 AWG) cable.
Connects to the remote CD/DVD Player output using a 0.75mm² (18 AWG) cable.
Connects to the positive battery terminal with a 40A fuse using a 4mm² (11 AWG) cable.
Output for loudspeaker connection, requiring attention to polarity and minimum impedance.
Includes short-circuit and thermal protection to safeguard the amplifier.
Specifies recommended wire gauges (11 AWG, 13 AWG, 18 AWG) and fuse (40A) for connections.
To Next Page
