Need help?Do you have a question about the Taramps SMART5 BASS and is the answer not in the manual?
Essential safety instructions for proper installation and usage, including handling precautions and electrical safety.
Connects the audio signal from the Head Unit, using shielded cables to prevent noise interference.
Sends the input signal to another amplifier, enabling cascading connections.
Sets input sensitivity for optimal adjustment to head unit output levels, from 4V to 0.2V.
High Pass Filter (8Hz-30Hz) and Low Pass Filter (60Hz-200Hz) for frequency range control.
Adjusts bass frequency (35Hz-55Hz) and boost level (0 to +10dB).
Accessory connection for monitoring amplifier status, including clipping and protection.
Connects transducers (speakers) with attention to polarity for optimal performance.
Connects to the head unit's remote output using an 18 AWG cable.
Features two internal fans for cooling; requires 1" space around the heatsink for proper heat spreading.
Connects to the negative battery pole using a minimum 2/0 AWG cable.
Connects directly to the positive battery pole with a fuse or circuit breaker (230A).
Specifies recommended wire gauges and fuse ratings for power, speaker, and remote connections.
To Next Page
General
