Targus Wireless Stow-N-Go
TM
Keypad
Troubleshooting
What do I do if the keypad does not work?
• Make sure that the polarity of the batteries is correct.
The positive (+) and negative (-) ends of each battery must
match the positive (+) and negative (-) connections in the
battery housing.
• Check that the receiver’s USB connector is fi rmly attached
to the USB port on your computer.
• Verify that the device drivers are installed.
• Make sure you have established a communication link.
See “Establishing a Communications Link”.
When I use the keypad, other wireless devices
work more slowly or fail temporarily – what
should I do?
• The keypad may cause interference with any cordless,
radio-based device that operates at 2.4 GHz, such as a
telephone, baby monitor, or toy. To reduce interference,
move the keypad’s receiver and the base unit of the
affected device as far away from each other as possible.
• You can also reset the keypad’s identifi cation code. To do
this, see “Establishing a Commun-ications Link”.
What do I do if the response time of the keypad
is slow or it intermittently stops working?
Try one or more of the following:
• Increase the distance between the receiver and the rest
of your computer equipment.
13
To Next Page