77
-
-
-
-
-
Proceed as follows:
• Press the Brush drive ON/OFF but-
ton.
The cleaning solution supply is
stopped.
• Drive on for a few meters so that the brushes keep on ro-
tating for a short time to avoid dripping.
Very important for TASKI contact pads!
• Press the Brush drive button ON/
OFF.
The display lights up and the brush
unit is stopped and lifted.
• Drive on for a few meters in order to absorb the remaining
drain water.
• To lift the tool, push the foot pedal
downwards until it engages.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Lift the squeegee.
Allow the suction unit to run on so
that the remaining waste water in the
hose is sucked up.
• Press the Suction unit ON/OFF but-
ton.
The display lights up; the suction en-
gine stops.
• Switch off the machine.
• Pull the suction hose from the connector.
• Lift the suction nozzle with your foot.
• Compress the lock springs. The suc-
tion nozzle is released and can be re-
moved from the suction nozzle
holder.
• Clean the suction nozzle under running water using a
brush.
• Take the drain hose out of the holder.
• Open the red or blue cover at the level of the handle, lower
the end of the hose slowly and empty the recovery or fresh
water tank.
To Next Page
Loading...
Need help?
General
