63
Insert suction hose
Application technique
Beginning work with the machine
Cleaning start
• Insert the plug into the mains socket.
Notice:
Check whether the suction hose is insert-
ed correctly.
• Correct insertion of the suction hose
prevents dust leaking.
Machine ergodisc 2000
Wet & base cleaning no
Spray cleaning no
Shampoo wet no
Shampoo dry no
Polish yes
Grinding no
Crystallization no
Attention:
For untrained users, it is recommended to
practise polishing on a testing area until
the handling of the machine is mastered.
The floor may be damaged by incorrect
operating of the machine.
Notice:
The pad turns at 2000 1/min. Use licensed
pads only.
• Start the machine by switching the
main switch on. (On = I).
• Release the foot lever and lower the
pad slowly.
Notice:
Hold the main cord in your hand.
Ensure that the main cord cannot come
into contact with the tool.
Notice:
Hold the machine with both hands.
• Operate the adjusting lever at the
machine handle and lower the steel
guide bar slowly until it is in a com-
fortable working position.
• Hold the safety switch (1) and oper-
ate the operating lever (2) at the
same time.
The pad is activated.
Notice:
The pad adheres to the floor when the ma-
chine is started.
Attention:
Do not stop when the machine is running.
The floor may be damaged.
EN
To Next Page
Loading...
