91
Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in sev-
eral work steps.
Replenishing cleaning solvent
Soiled water full
Recovery tank full:
End of operation
Notice:
More precise details regarding the direct
and indirect working method can be found
on the respective method sheet.
Please contact your TASKI customer con-
sultant for further details.
Notice:
The machine guiding might be impaired in
case of special combinations of flooring/
contamination and cleaning product.
Optionally available wheels can improve
the traction of the machine on the floor.
Please contact your TASKI customer con-
sultant.
Attention:
The flooring may be damaged when work-
ing without cleaning solution.
Notice:
A rattling sound of the pump indicates that
the fresh water tank is empty.
Attention:
The pump must never run dry for an ex-
tended period.
• The machine must be switched off.
• Open the tank lid.
• Fill the fresh water tank with water, see page 89.
• Add the cleaning product using the dosing cup.
• Close the tank lid.
• If the recovery tank is full, the floater
will be sucked onto the suction filter.
This will be indicated by a change of
the noise by increasing the suction
speed as well as residual water at the
bottom.
• Drain the recovery tank, see page 92.
• Switch off the water pump.
The cleaning solution supply is
stopped.
• Continue to drive a few meters.
Notice:
Very important for TASKI contact pads!
• To lift the tool, push the foot pedal
downwards until it engages.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Switch off the suction unit.
The switch lights up; the suction en
-
gine stops.
• Switch the machine off (ON/OFF)
and pull the power supply cord out of
the mains socket.
Attention:
The machine must now be emptied and
cleaned. Switch off the machine (main
switch) and remove the plug from the
mains socket.
EN
To Next Page
Loading...
Need help?
General