Taylor-Dunn B0-T48-48 Taylor Truck T48 User Manual

SECTION 3 PAGE 15
MB-T48-01
Filling and Checking the Fluid Level
6. Clean the cover and exterior of the master cylinder
and the surrounding area.
7. Remove the cap from the top of the master cylinder
and visually check the level of fluid.
8. Add DOT 3 brake fluid as needed, fill level 1/4” from
the top of the master cylinder.
9. Replace the cap on the master cylinder.
10. Reconnect the main positive and negative cables at
the batteries.
11. Remove the blocks from behind the wheels.
12. Release the park brake and test drive the vehicle.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
movement.
5. Disconnect the main positive and negative cables at the
batteries.

Taylor-Dunn B0-T48-48 Taylor Truck T48 Specifications

General

Brand	Taylor-Dunn
Model	B0-T48-48 Taylor Truck T48
Category	Trucks
Language	English