Taylor 150 - Page 24

20
Models 150, 152, 162, 168Operating Procedures
120501
Step 7
Finger- tighten the handscrews, making sure they are
tightened equally and that the door is snug. Do not
over- tighten the handscrews.
IMPORTANT! Handscrew and door damage can
result if the handscrews are over- tightened or if
one handscrew is tightened more than the other.
Step 8
Slide the two o- rings into the grooves on the draw
valve(s) and lubricate with Taylor Lube.
Figure 19
Note: For the Models 162/168, install the valve seal
in the grooves on the center draw valve and lubricate
with Taylor Lube. This special seal will prevent mix
from one freezing cylinder from traveling into the
second cylinder.
Figure 20
Step 9
Lubricate the inside of the freezer door spout(s) from
the botto m. Insert the draw valve(s) into the freezer
door from the bottom.
Figure 21
Note: The draw valve is installed correctly when the
slotted opening in the draw valve is visible through the
“window” of the freezer door .
Figure 22