22
Models 150, 152, 162, 168Operating Procedures
Note: Models 162/168 have three draw handles.
Slide the tip of the draw handle into the slot of the draw
valve, starting from the right. Slide the short pivot pin
through the far right draw handle. Slide the long pivot
pin through the far left and middle draw handles.
Figure 27
Step 13
Snap the design cap(s) over the bottom of the freezer
door spout(s).
Figure 28
Step 14
Lay the feed tube(s) in the bottom of the mix hopper(s).
Sanitizing
Step 1
Prepare an approved 100 PPM sanitizing solution (ex-
amples: Kay- 5R or Stera- SheenR). USE WARM
W ATER AND FOLLOW THE MANUFACTURER’S
SPECIFICATIONS.
Step 2
Pour one gallon (3.8 liters) of the sanitizing solution
into the hopper and allow it to flow into the freezing
cylinder.
Step 3
While the solution is flowing into the freezing cylinder,
brush- clean the mix hopper , mix level float stem, mix
level float, mix inlet hole, and feed tube.
Figure 29
Figure 30
To Next Page
Loading...
