11
Models 441 & 444 Important: To the Operator
Section 5 Important: To the Operator
Indicator Light “Mix Low”
The Models 441 and 444 are equipped with a “MIX
LOW” light located on the front of the machine. When
the light begins to flash, it indicates that the mix hopper
has a low supply of mix and should be refilled as soon
as possible. Always maintain at least 3” (76 mm) of mix
in the hopper to allow the mix feed assembly to operate
properly. If you neglect to add mix when the light
begins to flash, a freeze- up may occur, causing
eventual damage to the beater , blades, drive shaft,
and freezer door.
Figure 2
Symbol Definitions
The following chart identifies the symbol definitions
used on the operator switches.
= The “WASH” position.
= The “OFF” position.
= The “ON/AUTO” position.
Control Switch
The center position is “OFF”. The right position is
“AUTO”, which activates the beater motor and the
refrigeration syst em. The left position is “WASH”
which activates the beater motor only.
Figure 3
Reset Button
On the Models 441 and 444, the reset button is located
on the lower front panel.
The reset button protects the beater motor from an
overload condition. If an overload occurs, the reset
mechanism will trip. To properly reset the freezer ,
place the control switch in the “OFF” position. Press
the reset button firmly. Place the control switch in the
“WASH” position and observe the freezer’s
performance. Once satisfied, place the control switch
back in the “AUTO” position.
Figure 4
To Next Page
Loading...
