Taylor 441 - Page 27

23
Models 441 & 444 Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
3. The product appears too
thin. (Cont’d.)
g. Product is over beaten. g. Draw off some product to
allow fresh product to
enter the freezing cylinder.
--
h. Loss of water (W/C) h. Locate cause of water
loss and correct.
21
4. The mix in the hopper is
too cold.
a. The temperature is out of
adjustment.
a. Call service technician to
adjust the hopper
temperature.
--
5. The mix in the hopper is
too warm.
a. The temperature is out of
adjustment.
a. Call service technician to
adjust the hopper
temperature.
--
b. Hopper cover is not in
position.
b. Place the cover in
position.
17
c. The control switch is OFF. c. Place the control switch in
AUTO.
17
d. Warm mix was placed in
the hopper.
d. Mix added to the hopper
must be below 40_F
(4.4_C).
--
6. The drive shaft is stuck in
the gear box coupling.
a. Rounded corners of drive
shaft, coupling, or both.
a. Call service technician to
correct the cause and
replace the necessary
components. Do not
lubricate the end of the
drive shaft.
--
7. The freezing cylinder walls
are scored.
a. The scraper blade(s) are
not installed over the
beater pins. The pins on
the beater are broken.
a. Blade(s) must fit over the
pins on the beater . Call
service technician to
repair the beater
assembly.
14
b. The beater assembly is
bent.
b. Call service technician to
repair or replace beater
and to correct cause of
insufficient mix in freezing
cylinder.
--
c. Missing or worn front
bearing.
c. Install or replace the front
bearing.
14
8. Excessive mix leakage
into the rear drip pan.
a. Worn or missing drive
shaft seal.
a. Replace regularly. 25
b. Inadequate lubrication of
drive shaft seal.
b. Lubricate properly. 13
c. Worn rear shell bearing. c. Call service technician to
replace rear shell bearing.
--