Model 490 Operator Training
Controls Operating Procedures Troubleshooting Quiz
Quit
Home
Troubleshooting
Troubleshooting
Product too soft.
Cause: Out-of-date mix.
Remedy: Use only fresh mix.
Cause: Worn scraper blades.
Remedy: Replace regularly.
Cause: Dirty condenser.
Remedy: Clean monthly.
Cause: Not enough air space around unit.
Remedy: Allow for adequate air flow across
the condenser.
Cause: The TQC control is set incorrectly.
Remedy: Contact a service technician.
Product too stiff.
Cause: Inadequate mix in hopper.
Remedy: Fill hopper with mix.
Cause: TQC control is set incorrectly.
Remedy: Contact service technician.
To Next Page
Loading...
