Model 490 Operator Training
Controls Operating Procedures Troubleshooting Quiz
Quit
Home
Controls
Controls
The reset button is located on
the left side panel. The reset
button protects the beater
motor from an overload
condition. If an overload
occurs, the reset mechanism
will trip. To properly reset the
freezer, place the control
switch in the OFF position.
Press the reset button firmly.
Place the control switch in the
WASH position and observe
the freezer's performance. The
beater motor should operate
without tripping the overload.
Once satisfied, place the
control switch back in the
AUTO position.
Reset Button
To Next Page
Loading...
