Model 490 Operator Training
Controls Operating Procedures Troubleshooting Quiz
Quit
Home
Troubleshooting
Troubleshooting
Product not feeding into freezing cylinder.
Cause: Inadequate level of mix in the mix hopper.
Remedy: Mix inlet hole frozen.
Cause: Fill the mix hopper with mix.
Remedy: Mix hopper temperature needs adjustment.
Call service technician.
No freezer operation after placing
the unit in “AUTO.”
Cause: Unit unplugged.
Remedy: Plug into wall receptacle.
Cause: Beater motor out on reset.
Remedy: Allow the motor to cool and then
press the reset button.
Cause: The draw arm is not activated.
Remedy: After placing the freezer in the
AUTO mode, the draw arm must be raised to
activate the AUTO cycle.
Cause: Circuit breaker off or blown fuse.
Remedy: Turn breaker on or replace fuse.
To Next Page
Loading...
