Taylor 750 - User Manual

Other manuals for Taylor 750

Service Manual126 pages

Operator's Manual52 pages

Operating Instructions54 pages

Questions and Answers

R
Richard MurphySep 10, 2025
How to remove a stuck drive shaft from the drive coupling in my Taylor Ice Cream Maker?
- L
  longwilliamSep 10, 2025
  If the drive shaft is stuck in the drive coupling, it could be due to mix and lubricant accumulation; regularly brush clean the rear shell bearing area. Rounded corners on the drive shaft or coupling can also cause this, so replace worn components. Finally, a misaligned gear box can be the culprit; re-align it.
E
Erin ScottSep 12, 2025
What causes scored freezing cylinder walls in my Taylor Ice Cream Maker?
- A
  Anthony BenderSep 12, 2025
  Scored freezing cylinder walls can be caused by a missing or worn front bearing; install or replace it. Broken beater pins (pump style freezers only) can also cause this, so replace the beater assembly, ensuring scraper blades are properly attached over the pins. A bent beater assembly should be replaced. Finally, a misaligned gear box can contribute; re-align it.
A
Alexandra RobertsSep 13, 2025
Why is product collecting on top of the freezer door of my Taylor Ice Cream Maker?
- T
  Taylor AndersonSep 13, 2025
  If product is collecting on top of the freezer door, the top o-ring on the draw valve might be improperly lubricated or worn; lubricate it properly or replace the o-ring.
C
carlrossSep 15, 2025
What to do if the pump won't operate in PUMP mode on my Taylor Ice Cream Maker?
- T
  Timothy MillerSep 15, 2025
  If the pump won't operate in PUMP mode, try pushing the reset button. If that doesn't work, the membrane switch may be defective and need replacement.
T
Trevor MoralesSep 18, 2025
Why are the MIX LOW and MIX OUT probes not working on my Taylor Ice Cream Maker?
- M
  Michael HarperSep 18, 2025
  If the MIX LOW and MIX OUT probes aren't functioning, there might be milkstone build-up in the hopper. Clean the hoppers thoroughly.
H
halljesseNov 19, 2025
What to do if my Taylor Ice Cream Maker is not dispensing product?
- E
  Eric JacksonNov 19, 2025
  If your Taylor Ice Cream Maker isn't dispensing product, several factors could be at play. First, ensure the mix hopper isn't low; if the MIX OUT light is on, add mix. Next, verify the power switch is in the ON position and press the AUTO keypad. If the beater motor is out on reset, allow it to cool, turn the power switch OFF, press the reset button, turn the power switch ON, and press the WASH keypad, checking that the drive shaft turns CLOCKWISE. Then press the AUTO keypad. Also, check the air/mix pump assembly, ensuring it's correctly assembled and properly lubricated. Confirm the spring and poppet are correctly installed on the mix inlet fitting, replacing if necessary. If the mix pump ball crank is broken, replace it. Ensure the pump motor is activated by pushing the reset button and ...