Taylor 754 - Page 32

6-4
OPERATING PROCEDURES
Models 750, 751, 754, 774, 791, and 794
Operating Procedures
6
11. Install the draw valve(s). Slide the two O-rings into
the grooves on the draw valve(s) and lubricate.
Figure 6-10
Note: Models 754, 774, 791, and 794 have three draw
valves.
12. Lubricate the inside of the freezer door spout(s), top
and bottom, and insert the draw valve(s) from the
bottom until the slot in the draw valve(s) comes into
view.
Figure 6-11
13. Install the adjustable draw handle(s). Slide the O-ring
into the groove on the pivot pin, and lubricate.
Figure 6-12
Note: Models 754, 774, 791, and 794 have three draw
handles. Slide the fork of the draw handle in the slot of
the draw valve, starting from the right. Slide the pivot pin
through each draw handle as you insert them into the
draw valves.
14. Slide the fork over the bar in the slot of the draw
valve. Secure with the pivot pin.
Figure 6-13
Note: These machines feature adjustable draw handles
to provide the best portion control. The draw handles can
be adjusted for different flow rates. See
"Adjustable Draw
Handle" on page 5-4 for more information on adjusting
these handles.
Apply the appropriate
Taylor approved food safe lubricant.
Apply the appropriate
Taylor approved food safe lubricant.