OPERATING PROCEDURES
6-3
Models 750, 751, 754, 774, 791, and 794
Operating Procedures
6
Note: There are two gaskets and two front bearings for
the Models 754, 774, 791, and 794 door, one for each
freezing cylinder.
Figure 6-6
8. Slide the two O-rings into the grooves on the prime
plug(s). Apply an even coat of Taylor Lube to the
O-rings and shaft(s).
Figure 6-7
Note: There are two prime plugs for the Models 754,
774, 791, and 794 door, one for each freezing
cylinder.
9. Insert the prime plug(s) into the hole(s) in the top of
the freezer door, and push down.
Figure 6-8
Note: On Models 754, 774, 791, and 794, the short
handscrews go on the bottom, and the long handscrews
go on the top.
10. Insert the baffle rod(s) through the opening in the
beater(s) and seat the door flush with the freezing
cylinder. With the door seated on the freezer studs,
install the handscrews. Tighten equally in a
crisscross pattern to ensure the door is snug.
Figure 6-9
Apply the appropriate
Taylor approved food safe lubricant.
To Next Page
Loading...
