27
Models 750, 751, 754, 774, 791, 794 Operating Procedures
Figure 27
Step 4
Place the power switch in the ON position.
Figure 28
Step 5
Press the WASH key. This will cause the sanitizing
solution in the freezing cylinder to agitate. Allow it to
agitate for five minutes.
Figure 29
Step 6
Place an empty pail beneath the door spout and raise
the prime plug.
Figure 30
Step 7
When a steady stream of sanitizing solution is flowing
from the prime plug opening in the bottom of the
freezer door, lower the draw handle. Draw off all the
sanitizing solution.
Figure 31
Note: On the Models 754, 774, 791, and 794,
momentarily pull the center draw handle down to
sanitize the center door spout.
Step 8
Once the sanitizer stops flowing from the door spout,
raise the draw handle and press the WASH key,
cancelling the beater motor operation.
Note: You have just sanitized the freezer. Be sure
your hands are sanitized before continuing these
instructions.
To Next Page
Loading...
Need help?
General
