To Next Page

To Previous Page

Models 750, 751, 754, 774, 791, 794 Operating Procedures

Step 5

Return to the freezer with a small amount of cleaning

solution. Brush clean the rear shell bearing(s) at the

back of the freezing cylinder(s) with the black bristle

brush.

Figure 36

Step 6

Remove the rear drip pan(s) and take to the sink for

cleaning.

Note: If the drip pan is filled with an excessive amount

of mix, refer to the Troubleshooting Guide.

Step 7

Thoroughly brush clean all disassembled parts in the

cleaning solution making sure all lubricant and mix film

is removed. Take particular care to brush clean the

draw valve core(s) in the freezer door. Place all the

cleaned parts on a clean, dry surface to air dry

overnight.

Step 8

Wipe clean all exterior surfaces of the freezer.

Taylor 754 Original Operating Instructions

Other manuals for Taylor 754