EasyManuals Logo

Taylor 791 User Manual

Taylor 791
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
3-2
SAFETY
Models 750, 751, 754, 774, 791, and 794
Safety
3
WARNING! Avoid injury.
DO NOT allow untrained personnel to operate
this machine.
DO NOT put objects or fingers in the door spout.
DO NOT operate the machine unless all service
panels and access doors are fastened with
screws.
DO NOT remove the machine door or beater
assembly unless the control switches are in the
OFF position.
Failure to follow these instructions may result in
contaminated product or severe personal injury to fingers
or hands from hazardous moving parts.
WARNING! This machine has many sharp
edges that can cause severe injuries.
DO NOT put objects or fingers in the door spout.
This may contaminate the product and cause
severe personal injury from blade contact.
USE EXTREME CAUTION when removing the
beater assembly. The scraper blades are very
sharp.
Failure to follow these instructions may result in
electrocution or damage to the machine. Contact your
local authorized Taylor distributor for service.
CAUTION! This machine must be placed on a
level surface. Failure to comply may result in personal
injury or machine damage.
NOTICE! Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please see
the cleaning section of this manual for the proper
procedure to clean this machine.
WARNING! Only install this machine in a
location where its use and maintenance is restricted to
trained personnel. Failure to comply may result in
personal injury.
Do not run the machine without product. Failure to follow
this instruction can result in damage to the machine.
Do not obstruct air intake and discharge openings:
Counter Model: 6 in. (152 mm) minimum airspace on
both sides and 0 in. on the rear.
Console Models: 3 in. (76 mm) minimum airspace on all
sides.
Failure to follow this instruction may cause poor freezer
performance and damage to the machine.
These freezers are designed to operate indoors, under
normal ambient temperatures of 70°F to 75°F
(21°C to 24°C). The freezers have successfully
performed in high ambient temperatures of 104°F (40°C)
at reduced capacities.
Noise Level: Airborne noise emission does not exceed
78 dB (A) when measured at a distance of 39 in. (1.0 m)
from the surface of the machine and at a height of
62 in. (1.6 m) from the floor.

Other manuals for Taylor 791

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Taylor 791 and is the answer not in the manual?

Taylor 791 Specifications

General IconGeneral
BrandTaylor
Model791
CategoryFreezer
LanguageEnglish

Related product manuals