7-2
OPERATOR’S CHECKLIST
Models 750, 751, 754, 774, 791, and 794
Operator’s Checklist
7
If your machine is equipped with an auxiliary
refrigeration system, check the auxiliary
condenser for dirt and lint. Dirty condensers will
reduce the refrigeration capacity of the mix
hopper. Condensers must be cleaned monthly
with a soft brush. Never use screwdrivers or
other metal probes to clean between the fins.
Failure to follow this instruction may result in
electrocution.
WARNING! Always disconnect electrical
power prior to cleaning the condenser. Failure to follow
this instruction may result in electrocution.
If your machine is water-cooled, check the water
lines for kinks or leaks. Kinks can occur when the
machine is moved back and forth for cleaning or
maintenance. Deteriorated or cracked water lines
should be replaced only by an authorized Taylor
distributor.
Winter Storage
If the place of business is to be closed during the winter
months, it is important to protect the freezer by following
certain precautions, particularly if the building is subject
to freezing conditions.
• Disconnect the freezer from the main power source
to prevent possible electrical damage.
• On water-cooled freezers, disconnect the water
supply. Relieve pressure on the spring in the water
valve. Use air pressure on the outlet side to blow out
any water remaining in the condenser. This is
extremely important. Failure to follow this
procedure may cause severe and costly damage to
the refrigeration system.
• Your local Taylor distributor can perform this winter
storage service for you.
• Wrap detachable parts of the freezer such as beater,
blades, driveshaft, and freezer door, and place them
in a protected dry place. Rubber trim parts and
gaskets can be protected by wrapping them with
moisture-proof paper. All parts should be thoroughly
cleaned of dried mix or lubrication, which can attract
mice and other vermin.
To Next Page
Loading...
