OPERATING PROCEDURES
6-5
Models 750, 751, 754, 774, 791, and 794
Operating Procedures
6
15. Snap the design cap(s) over the end of the door
spout(s).
Figure 6-14
16. Install the front drip tray and the splash shield under
the door spout(s).
Figure 6-15
17. Slide the rear drip pan(s) into the hole in the side
panel.
Figure 6-16
18. Models 791 and 794: Slide the rear drip pan into the
hole in the front panel.
19. Slide two O-rings on one end of the air tube. Slide
two O-rings on the other end of the air tube.
Figure 6-17
20. Slide the small O-ring into the groove of the air
orifice. Do not lubricate the O-ring.
Figure 6-18
Note: Make sure the hole in the air orifice is clean
and is not clogged. If the hole in the air orifice should
become clogged, use soap and hot water to clear the
hole.
Do not enlarge the hole in the air orifice.
To Next Page
Loading...
