Section 6
6-1
Model 810, 812, 820, 822, 828 Series
Operating Procedures
6
Operating Procedures
The three-platen Model L810 has been selected to
illustrate the step-by-step procedures. For grills equipped
with fewer than three platens, perform the following steps
as appropriate for your grill platen configuration.
Daily Opening Procedures
Before operating the grill, the release sheets must be
installed on the upper platens. The release sheets are
reversed and rotated on a daily basis (dark color side vs.
light color side).
Perform the following steps for installing release sheets:
WARNING! Make sure the grill is cool before
attempting to install or remove release sheets. Failure to
comply may cause burns from machine surfaces.
1. Slide the release sheet retainer through the hemmed
end of the release sheet.
Figure 6-1
2. Hook the release sheet retainer on the release sheet
shoulder screws at the top of the upper platen.
Figure 6-2
3. Hold the non-hemmed end of the release sheet.
Gently pull the sheet tight, wrapping it around the
platen in a side-to-side manner.
Figure 6-3
Note: Check the alignment of the release sheet and
make sure it fits smoothly over the upper platen.
To Next Page
Loading...
