OPERATING PROCEDURES
6-15
Model 810, 812, 820, 822, 828 Series
Operating Procedures
6
Cleaning After Each Run of Product
1. Using the grill scraper, scrape the grease on the
lower grill surface from front to back. Do not scrape
across the rear of the lower grill surface with the grill
scraper.
Figure 6-41
2. Use the wiper squeegee to clean the release sheet
on the upper platen. Hold the handle at a slight
upward angle. Use a downward motion to clean the
sheet.
Note: Do not use excessive pressure when wiping
the release sheet with the squeegee, since this can
scratch or tear the release sheet.
Figure 6-42
3. Using the wiper squeegee, push the grease at the
rear of the lower grill surface into the grease can. Do
not use the grill scraper for this step.
Figure 6-43
4. Use the grill cloth to clean the back splash plate and
the bullnose areas as needed during operation.
Note: To increase the life of the release sheet, wipe
it with a clean, sanitizer-soaked, folded grill cloth a
minimum of four times every hour.
WARNING! The upper platen surface is very
HOT. Use extreme caution when wiping the release
material sheet.
Failure to comply can result in severe
personal injury.
To Next Page
Loading...
