OPERATING PROCEDURES
6-21
Model 810, 812, 820, 822, 828 Series
Operating Procedures
6
Figure 6-64
NOTICE! To avoid damaging the machine:
• Never use grill screens on the upper platen or
the lower grill surface.
• Never use any abrasives or cleaners other than
the approved cleaner.
• Never allow the grill scraper or the abrasive
cleaning materials to come in contact with the
release sheet.
41. Pour a small amount of lukewarm water on a clean,
sanitizer-soaked grill cloth while holding it over the
lower grill surface. Wipe the lower grill surface until
all residue is removed.
Figure 6-65
IMPORTANT! Use the grill cleaning pad and
holder ONLY. Using any other pad and holder will
damage the release sheets.
Note: Contact your local Taylor distributor to purchase
the correct grill cleaning pad and holder. (See
page 4-7.)
42. Place the release sheets flat on the lower grill
surface. Gently clean both sides of the sheets with an
approved high-temperature grill cleaner and the grill
cleaning pad and holder.
Figure 6-66
43. Rinse both sides of the release sheets with a clean,
sanitizer-soaked grill cloth.
Figure 6-67
44. Place the release sheets on a clean, flat surface to
air-dry overnight.
45. Wipe the lower grill surface with a clean, sanitizer
soaked grill cloth. Repeat until no visible soil remains.
46. Remove and empty the grease cans.
To Next Page
Loading...
