Taylor C602 - Timers

35
Model C602
Systems, Controls and Operations
Timers
Two Minute Stir Cycle
If either side of the machine is in the STANDBY
mode, the beater motor for that side will turn on for
six seconds every two minutes.
If any hopper is above the cut- in temperature, the
beater stir cycle timer is activated.
Soft Serve - If the machine is in the HEAT mode,
this two minute stir cycle will continue until the
freezing cylinder temperature rises above 135_F
(57_C). If the machine is in the AUTO mode or the
COOL phase of the Heat Treatment Cycle, and the
hopper is calling for refrigeration, the beater motor
and compressor will continue to run until the
viscosity setpoint has been reached.
Shake - If the machine is in the AUTO mode and
the hopper is calling for refrigeration, the beater
motor will run once every two minutes. If the
freezing cylinder product viscosity has been satisfied
during this beater run time, the beater motor will turn
off. Otherwise, the compressor will also turn on and
run until the freezing cylinder product viscosity has
been satisfied. During the Heat Treatment Cycle the
beater motor runs continuously until viscosity is
satisfied in the Cool Phase after which the beater
motor will run as in the AUTO mode to cool the
hopper.
Glycol Pump Timer
If either side of the machine is operating in the
AUTO mode, and the hopper requires refrigeration,
the glycol pump will operate one minute, discontinue
for two minutes, then operate again for one minute.
This pattern continues until hopper refrigeration is no
longer required.
Mix Pump Timer
Shake - The mix pump will run for 10 seconds
anytime the unit is placed in the AUTO mode, but
not f rom STANDBY.
Soft Serve - The mix pump will run for 30 seconds
anytime the unit is placed in the AUTO mode.
Mix Draw Timer
(Soft Serve Application Only)
During the AUTO mode, the mix pump will run for 5 -
30 seconds every time product is drawn from the
machine. The factory setting is 10 seconds.
Draw Safety Timer
(Shake Application Only)
During the AUTO mode, if the pyroelectric sensor
has not detected the product level, the safety timer
will terminate the draw. The draw safety timer is
adjustable from 3 - 60 seconds. The recommended
setting is five seconds longer than the time required
to dispense the largest serving size (International =
11 seconds, Triple Thick Shake = 24 seconds).
Brush Clean Countdown
The Brush Clean Countdown displays on the control
panel. It counts the number of days before the next
brush cleaning is required. When the display has
counted down to “1”, the following message will
appear on the VFD screen. (See Figure 82.) The
machine must be disassembled and brush cleaned
within 24 hours.
BRUSH CLEAN ON MM/DD
Figure 82
24 Hour Last Heat Cycle Event
If the machine runs longer than 24 hours without a
successful Heat Treatment Cycle, the machine will
soft lock.