Taylor C708 - Section 6 Operating Procedures; Freezing Cylinder Assembly

31
Models C708 & C716 Operating Procedures
Freezer Door Assembly
The assembly of the C708 freezer door is different
from the C716 freezer door. Please follow the
appropriate instructions for your machine.
Model C708 Freezer Door Assembly
Step 1
Place the door gasket into the groove on the back of
the freezer door. Slide the front bearing over the
baffle rod so the flanged edge is against the door.
DO NOT lubricate the gasket or bearing.
(See Figure 21.)
Figure 21
Step 2
Slide the three o-rings into the grooves on the draw
valve and lubricate. (See Figure 22.)
10423
Figure 22
Step 3
Lightly lubricate the inside of the top of the freezer
door valve cavity. (See Figure 23.)
Figure 23
Step 4
Insert the draw valve from the top, with the draw
handle slot facing forward. (See Figure 24.)
Figure 24